Guide overlay
Scientists 3D print cartilage to repair damaged windpipes
Posted by 3DP4E
MEDICAL
PRINTERS

By Jon Fingas | Engadget

Believe it or not, scientists aren't yet finished discovering new ways to 3D print body parts. A team at the Feinstein Institute for Medical Research has developed a 3D printing technique that lets them produce cartilage for repairing damaged tracheas, better known to you and I as windpipes. They use an off-the-shelf 3D printer (in this case, a MakerBot Replicator 2X Experimental) to create a scaffold for the cartilage out of the same PLA filament you'd use for everyday 3D printing projects. After that, they cover the scaffold in a mix of chondrocytes (healthy cartilage cells) and collagen, 'baking' it in a custom bioreactor to make sure the cells grow properly.

The new approach is just a proof of concept right now, and researchers estimate that it could take up to five years before it's helping to repair airways in humans. If it works as promised, though, it could do a lot for fixing not just tracheas, but other body parts. Instead of relying on either slow conventional reconstruction methods or expensive biological printers, you could use relatively cheap hardware to get replacements within hours. That, in turn, would both lower medical costs and let patients resume their lives that much sooner.

Share
0 Comments

Please login to post a comment.

2b096b3837c7eda650234d1b7002927686ee1713 thumb
Posted on May 4, 2014
FASHION

Shapeways believes nothing is sexier than 3D printing, especially when they are 3D printing the snow angel outfit for [Victoria's Secret Fashion Show](http:/...

8599dfbdffad347cc42fbd88a439f460a49a1adc thumb
Posted on May 7, 2014
INDUSTRY

By Mitch Hensley | 3D Print